|
|
|
|
|
|
HomeCar CareExterior CareCar Wash EquipmentMar-Hyde - One-Step Rust Converter Primer Sealer, 10 oz. aerosol (3509) |
|
|  | | | Customer Reviews: | | | Average Customer Review: ( 4 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
39 of 40 found the following review helpful:
Mar-Hyde - rust convert truck frame Jun 10, 2009
By J. Fishel
Well, my 2005 truck had a lot of surface rust on the frame, so I thought I would nip it in the bud. I read a lot online about what to use and decided to go with the mar-hyde rust converter.
I used about 2 full cans to rust convert the frame, drive shaft, axles and hitch of 1 mid-sized pickup. I will probably go back and touch up with another can. I tried to avoid spraying on plastic parts, but it doesn't say anywhere that it will hurt plastic or rubber parts. It does say not to spray on any surface that exceeds 200 degrees, so I definitely avoided the exhaust and engine. The body itself looked perfect so I did not use any on the body. It seemed to do a good job. By the day after I sprayed, the rust had all converted to a smoother darker finish.
On the down side, the fumes seem very noxious. I used it outside, on a slightly breezy warm day and the fumes were still strong, especially if you got in the "cloud." I would only use it outside and preferably with some sort of mask and away from children or pets.
I am planning on coating the underside of the truck with fluid film also, but I have not done this yet. I am not planning on painting the frame. Its been about 2 weeks since I performed the initial treatment and I have had no problems.
Well, there is my story about mar-hyde. I am not an expert, but there is my experience. hope it helps someone.
26 of 26 found the following review helpful:
 Love this stuff Nov 08, 2008
By Matthew Krause
"Matt"
Been using One-Step for years. It kills rust dead in its tracks. Wire brush the loose rust and spray it on. It converts rust into black paint. I do recommend topcoating over it. Typically I would use One-Step, then primer over that, then top coat it. I've used it on cars(frame and body both) as well as tractors.
4 of 4 found the following review helpful:
 One-Step Rust Converter Primer Sealer, 10 oz. aerosol Aug 22, 2011
By ToniK
I am still experimenting with this product. First time I used it the product flaked off in 3 days. I am following instructions but it is no adhering. I did read online that product needs rust to adhere so I let it rust up again and will try again with the One-Step Rust Converter Primer Sealer, 10 oz. aerosol.
6 of 12 found the following review helpful:
rust converter Nov 20, 2009
By T. M. Gore
Item is as described and delivery was fast. Can't ask a lot more than that!
|
| | |
|
* Estimated shipping rate for US 48 states. Final rate calculated at checkout. |
|
|
|
